SRS Unit Replacement

SRS Unit Replacement

Removal

NOTE: If you are disconnecting only SRS unit connector A, skip step 2.

1. Disconnect the negative cable from the battery, then wait 3 minutes before starting work.
2. Disconnect both seat belt tensioner connectors.
3. Remove the driver's and passenger's console side trim.
4. Disconnect SRS unit connector A (28P), SRS unit connector B (28P), SRS unit connector C (28P), and remove the TORX bolts (D), then pull out the SRS unit.






Installation

1. Install the new SRS unit (A) with TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.






NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.

2. Reconnect both seat belt tensioner connectors.
3. Reconnect the negative cable to the battery.
4. Install all removed parts.
5. Calibrate the ODS unit.
6. Do the ODS unit operation check.
7. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.