ODS Unit Operation Check

ODS Unit Operation Check

'07-08 Models

Check the ODS operation after any of these actions.
- Replacement of front passenger's seat component(s) (except ODS unit and/or front passenger's weight sensors)
- After a vehicle collision
- SRS unit replacement

Pre-Operation Check Set-up

- Make sure all the components of the front passenger's seat are correctly installed.
- Position the front passenger's seat to the rearmost position. Adjust the seat recline to the forward most position.
- Do not move the seat from this position.
- Make sure nothing is on or under the front passenger's seat.
- Make sure there is nothing in the front passenger's seat-back pocket.
- Keep the windows closed.
- Do all calibration procedures, except test-driving, in the service bay.
- Make sure the vehicle is on level ground.
- Keep the A/C and heater off.
- Do not touch the passenger's seat during the operation check.
- Do not expose the front passenger's seat to sudden temperature changes.
- Make sure all aftermarket devices such as amplifiers, fluorescent lights, air purifiers, CB or HAM radios, etc. are turned off.

After Replacing Front Passenger's Seat Component(s)

1. Connect the HDS to the data link connector (DLC) (A).






2. Drive the vehicle, accelerate to 20 mph (36 km/h), then stop on level ground.
3. From the HDS Main Menu, select SRS, then Inspection. In the HDS Inspection Menu, select "SEAT OUTPUT CHK" and follow the prompts until the ODS unit operation check has been completed.