Starter Solenoid: Testing and Inspection
Starter Solenoid Test1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped).
2. Disconnect the negative cable from the battery.
3. Remove the starter cable terminal (A), BLK/WHT wire connector (B), and motor cable (C).
4. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
- If there is continuity, go to step 5.
- If there is no continuity, replace the solenoid.
5. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
- If there is continuity, the solenoid is OK.
- If there is no continuity, replace the solenoid.
6. Install in the reverse order of removal.
7. Connect the negative cable.
8. Enter the anti-theft codes for the audio system and navigation system (if equipped).
9. Do the power window control unit reset procedure.
10. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).