Transmission Position Sensor/Switch: Testing and Inspection
Transmission Range Switch Test1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery hold-down bracket, and remove the battery and the battery tray.
4. Remove the intake manifold cover, the intake air duct, the resonator, and the air cleaner housing.
5. Remove the battery base.
6. Disconnect the transmission range switch connector.
7. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.
8. The transmission range switch test is finished if the test results are OK.
If there is no continuity between any terminals, check the transmission range switch installation. If the switch installation is OK, replace the switch.