Power Window Control Module: Testing and Inspection
Resetting the Power Window Control UnitResetting the driver's power window is required when any of the following have occurred:
- Power window regulator replacement or repair
- Power window motor replacement or repair
- Window run channel replacement or repair
- Driver's door glass replacement or repair
- Power is removed from a power window control unit while the power window timer is ON.
Using the HDS
1. Connect the HDS to the DLC.
2. Turn the ignition switch ON (II), then enter the mileage at the prompts.
3. Select "BODY ELECTRICAL" from the "System Selection menu."
4. From the "BODY ELECTRICAL" System Select menu, select "Power Windows".
5. From the "Mode menu", select "Adjustments".
6. From the "Adjustment" menu, select "Window P Reset" for driver's side window.
7. Follow the prompts on the screen.
8. Confirm that the power window control unit is reset by using the driver's power window AUTO UP and AUTO DOWN function.
Without the HDS
1. Turn the ignition switch ON (II).
2. Move the driver's power window all the way down by using the driver's power window DOWN switch.
3. Open the driver's door.
NOTE: Steps 4-7 must be done within 5 seconds of each other.
4. Turn the ignition switch OFF.
5. Push and hold the driver's power window DOWN switch.
6. Turn the ignition switch ON (II).
7. Release the driver's power window DOWN switch.
8. Repeat step 4-7 three more times.
9. Wait 1 second.
10. Confirm that AUTO UP and AUTO DOWN do not work. If AUTO UP and DOWN work, go back to step 1.
11. Move the driver's power window all the way down by using the driver's power window DOWN switch.
12. Pull up and hold the driver's power window UP switch until the window reaches the fully closed position, then continue to hold the switch for 1 second.
13. Confirm that the power window control unit is reset by using the driver's power window AUTO UP and AUTO DOWN function.
If the window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 second time limit between steps. If it still does not work, go to B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A