Do you have access to Mitchell1 Prodemand, or eautorepair.net DIY? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously
Driver's Power Window Motor Test
Driver's Power Window Motor TestMotor Test
1. Remove the door panel.
2. Disconnect the 6P connector (A) from the power window motor.
3. Test the motor in each direction by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
4. If the motor does not run or fails to run smoothly, replace it.
Pulser Test
5. Reconnect the 6P connector to the power window motor.
6. Check for voltage between the terminals.
- There should be battery voltage between the No. 6 (+) and No. 5 (-) terminals when the ignition switch is ON (II).
- Connect an analog voltmeter between the No. 3 (+) and No. 5 (-) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
- Connect an analog voltmeter between the No. 2 (+) and No. 5 (-) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0-5 V).
7. If the voltage is not as specified, do the power window master switch input test (terminals No. 4, No. 6 and No. 17).
8. If the switch test is OK, replace the power window motor.
9. Reset the power window control unit.