Operation CHARM: Car repair manuals for everyone.

Recall - Accessory Hood Mask Defect

09-081

December 23, 2009

Applies To:
2008-10 Accord 4-Door With Accessory Nose Mask - ALL

Safety Recall: Nose Mask May Prevent the Hood From Locking

BACKGROUND

If the vehicle is equipped with a Honda Genuine accessory nose mask, it is possible for the nose mask material to interfere with part of the hood latch. If the hood is not completely closed and the nose mask interferes with the secondary hood latch mechanism, the hood may fully open while the vehicle is being driven, resulting in reduced driver visibility that could increase the possibility of a crash.

CUSTOMER NOTIFICATION





All owners of potentially affected vehicles will be sent a notification of this campaign. An example of the customer notification is at the end of this service bulletin.

Only about 3,800 vehicles within the VIN range are affected. To verify vehicle eligibility, check that the vehicle has a Honda Genuine nose mask.

Some vehicles affected by this campaign may be in your new or used vehicle inventory. According to federal law, these vehicles cannot be sold or leased until they are repaired. Should a dealership sell an unrepaired vehicle that subsequently causes an injury or damage because of the recalled item, the dealership will be solely responsible to the damaged party, and will be required to defend and indemnify American Honda for any resulting claims.

CORRECTIVE ACTION

Replace the hood section of the nose mask.

PARTS INFORMATION

Nose Mask: P/N 08P35-TA0-101-01

WARRANTY CLAIM INFORMATION

In warranty:
The normal warranty applies.

Operation Number: 0481 Al

Flat Rate Time: 0.2 hour

Failed Part: P/N 08P35-TA0-100
H/C 8755696

Defect Code: 5NM00

Symptom Code: R2100

Skill Level: Repair Technician

REPAIR PROCEDURE

1. Open the hood, and remove the hood section of the nose mask.

2. Install the new mask:

^ Fit the corners of the new mask around the hood.

^ Adjust the mask so it fits smoothly over the edges.

^ Attach the hooks to the hood.

NOTE:

- Remove and install the hooks by inserting your finger into the hood strap of each hook.

- Pulling the hooks with too much force can break the hood strap.





Disclaimer