Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front inner fender:
- 2-door Front Inner Fender Replacement (2-Door)

- 4-door Front Inner Fender Replacement (4-Door)

3. Disconnect the engine compartment wire harness 2P connector (A). Using a TORX T30 bit, remove the TORX bolt (B), then remove the front impact sensor (C). Replace the bolt.






Installation

1. Install the front impact sensor with a new TORX bolt (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).

2. Do the battery terminal reconnection procedure. Procedures

3. Reinstall all removed parts.

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. Confirm proper operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.