Removal and Replacement

Starter Removal and Installation

Removal

1. Do the battery terminal disconnection procedure. Procedures

2. Remove the splash shield.






3. Remove the intake manifold bracket.






4. Remove the harness clamp (A), and the two bolts (B) securing the starter, then remove the starter from the engine.






5. Disconnect the positive starter cable (A) and the S terminal connector (B).

6. Remove the harness clamp (C), then remove the starter.






Installation

1. Install the harness clamp (A).

2. Connect the positive starter cable (B) and S terminal connector (C). Make sure the crimped side of the starter cable ring terminal faces away from the starter when you connect it.






3. Install the starter, and tighten the two bolts, then install the harness clamp (A).






4. Install the intake manifold bracket.






5. Install the splash shield.

6. Do the battery terminal reconnection procedure. Procedures

7. Start the engine to make sure the starter works properly.