Keyless Entry Transmitter: Testing and Inspection

Keyless Transmitter Programming/Deleting

07- 09 models

Storing transmitter codes:

The codes of up to three transmitters can be stored into the keyless receiver unit memory. (If a fourth code is stored, the code that was programmed first will be erased.)

NOTE: It is important to maintain the time limits between the steps. Make sure the doors and the tailgate are closed.

1. Turn the ignition switch to ON (II).

2. Within 1 to 4 seconds, push the transmitter lock or unlock button.

3. Within 1 to 4 seconds, turn the ignition switch to LOCK (0).

4. Within 1 to 4 seconds, turn the ignition switch to ON (II).

5. Within 1 to 4 seconds, push the transmitter lock or unlock button.

6. Within 1 to 4 seconds, turn the ignition switch to LOCK (0).

7. Within 4 seconds, turn the ignition switch to ON (II).

8. Within 1 to 4 seconds, push the transmitter lock or unlock button.

9. Within 1 to 4 seconds, turn the ignition switch to LOCK (0).

10. Within 4 seconds, turn the ignition switch to ON (II).

11. Within 1 to 4 seconds, push the transmitter lock or unlock button.

12. The door lock actuators will activate to confirm that the system has entered the transmitter programming mode. Within 1 to 4 seconds, push the transmitter lock or unlock button again to program that transmitter. The door lock actuator will activate to confirm that the transmitter code is stored.

13. Within 10 seconds, press the transmitter lock or unlock buttons on the two additional transmitters. The door lock actuators will activate each time after you press the lock or unlock button to confirm that the transmitter code is stored.

14. Turn the ignition switch to LOCK (0), and remove the key.

15. Confirm proper operation of the transmitters.