Center Console Removal/Installation (SC Models)

Center Console Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*

SC Model

NOTE:

- Put on gloves to protect your hands.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to scratch the center console, dashboard, or the related parts.

1. Pull up on the parking brake lever.

2. Push in where indicated to release the hook (A) on the beverage holder (B), then remove the holder.






3. Remove the front trim mat (A). Pull up the rear portion of the center console front trim (B) to detach the clips (C) and the hook (D), then pull it backward to release the clips (E). Remove the front trim.






4. Remove the center console rear trim (A).
-1 Open the armrest, and remove the bolt (B) from the bottom of the trim.
Pull the right side of the trim up to release the hooks (C) and the clips (D).
-3 Pull the left side of the trim up to detach the clips (E) and the hooks.
Remove the trim by pulling it up and over the parking brake lever.






5. Disconnect the console accessory power socket connector (A) from the bottom of the center console. Remove the bolt (B) and the screws (C).






6. Remove the console box mat (A) and the bolts.






7. Lift up the rear of the console, and pull it backward to release the pins (A) and the clips from the dashboard, then remove the center console (B).






8. Remove the tray mat (A). Pull the rear portion of the center floor tray (B) up and backward to release the clips (C, D), then remove the tray from the subwoofer.

9. Install the console in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips and the hooks into place securely.

- Make sure the console accessory power socket connector is plugged in properly.