Dashboard Center Panel Removal/Installation

Dashboard Center Panel Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to scratch the dashboard or the related parts.

1. Release the lower clips in the radio panel (A) by putting a hook-shaped tool into the notches (B), and pulling out carefully. Pull out on the radio panel to release the upper clips.






2. M/T model: Remove the shift knob (A).






3. Apply protective tape to the lower portion of the center panel (A) to prevent damage. Carefully insert the appropriate trim tool to release the clips, then pull out the panel. Disconnect the heater control unit connector (B), the hazard warning switch connector (C), and the passenger's airbag cutoff indicator connector (D).

4. Install the panel in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.

- Push the clips into place securely.