Entry Lights Control System Control Unit Input Test

Entry Lights Control System Control Unit Input Test

1. Before testing, troubleshoot the multiplex control system. Multiplex Control System Troubleshooting

2. Remove the driver's dashboard lower cover. Drivers Dashboard Lower Cover Removal/Installation

3. Disconnect under-dash fuse/relay box connectors O, Q, X and Y.
NOTE: All connectors are shown from wire side of female terminals.

4. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.

- If the terminals look OK, go to step 5.

5. With the connectors still disconnected, do these input tests at the following connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, go to step 6.





6. Reconnect the connectors to the under-dash fuse/relay box, and do these input tests at the following connectors.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, the multiplex control unit must be faulty, replace the under-dash fuse/relay box assembly.