Side Curtain Airbag Replacement

Side Curtain Airbag Replacement

NOTE: If replacing the side airbag after deployment, refer to Component Replacement/Inspection After Deployment Service and Repair for a complete list of other parts that must also be replaced.

Removal

NOTE:

- Review the interior trim replacement procedure before doing repair or service. Interior Trim Removal/Installation - A-Pillar Trim

- Removal of the side curtain airbag must be done according to the precautions and procedures. Technician Safety Information

- The side curtain airbag system consists of the side curtain airbag module, including the roof trim, front grab handle, all grab handle brackets and shielding protector. When the side curtain airbag has been deployed, these parts should be replaced. Service and Repair

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the headliner. Service and Repair

3. Disconnect the roof wire harness 2P connector (A) from the side curtain airbag 2P connector.






4. Remove the mounting bolts (A) from the inflator tether bracket and clips (B) from the protector.






Installation

NOTE:

- Installation of the side curtain airbag must be done according to the precautions and procedures. Technician Safety Information

- If the airbag is frayed, or has only other visible damage, replace it. Do not attempt to repair an airbag.

- When you install the airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the bracket bolts.

- Make sure that the side curtain airbag inflator tether brackets (A) are installed properly.

- Make sure the tether straps (B) are not twisted, and there are no tubes, hoses, or harnesses routed over the straps. Otherwise, the airbag may not deploy properly.

- If there is any damage to the side curtain airbag, do not try to repair it. Replace any damaged side curtain airbag.

- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.

1. Place the side curtain airbag assembly on the side of the roof. Tighten the side curtain airbag mounting bolts (C), then install the clips (D). Make sure the clips are completely seated.






2. Connect the roof wire harness 2P connector (A) to the side curtain airbag 2P connector.

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. After installing the side curtain airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

6. Install all removed parts.

7. Confirm proper headliner/pillar trim overlap. Service and Repair