Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2009 >> Element 4WD L4-2.4L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Side Impact Sensor (First) Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la
If it fails: lemon-manuals.org.ua

Or, hide this message: temporarily or permanently

Side Impact Sensor (First) Replacement




Side Impact Sensor (First) Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front seat assembly.

3. Remove the door sill trim.

4. Disconnect the floor wire harness 2P connector (A) from the side impact sensor (first) (B).

5. Remove the TORX bolt (C) using a TORX T30 bit, then remove the side impact sensor.






Installation

1. Install the side impact sensor (first) (A) with a new TORX bolt (B), then connect the floor wire harness 2P connector (C) to the side impact sensor (first).

2. Reinstall the seat assembly.

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. After installing the side impact sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

6. Install all removed parts.





pro multis · About Operation CHARM