Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE:

- Removal of the driver's seat position sensor must be performed according to the precautions and procedures described at the beginning of the SRS section. Technician Safety Information

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the driver's seat assembly.

3. Disconnect the seat position sensor harness 2P connector (A) from the driver's seat position sensor (B).

4. Remove the TORX bolt (C) using a TORX T30 bit, then remove the driver's seat position sensor.






Installation

NOTE:

- Be sure to install the harness so it is not pinched or interfere with other parts.

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the driver's seat position sensor (A) with a new TORX bolt (B), then connect the seat position sensor harness 2P connector (C) to the driver's seat position sensor.

2. Install the driver's seat assembly.

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs. Initial Inspection and Diagnostic Overview

5. Check the operation of the driver's seat position sensor with the HDS.