M/T Mainshaft Bearing and Oil Seal Replacement

M/T Mainshaft Bearing and Oil Seal Replacement

Special Tools Required

- Oil seal driver, 65 mm 07JAD-PL90100
- Adjustable bearing puller, 20-40 mm 07736-A01000B
- Bearing driver attachment, 42 x 47 mm 07746-0010300
- Driver handle, 15 x 135L 07749-0010000Slide hammer, 3/8 ''-16 UNF commercially available
1. Remove the ball bearing (A) from the clutch housing (B) using the 20-40 mm adjustable bearing puller (C) and a commercially available 3/8 ''-16 UNF slide hammer (D).






2. Remove the 28 x 43 x 7 mm oil seal (A) from the clutch housing. Be careful when removing the seal so the clutch housing is not damaged.






3. Drive in a new 28 x 43 x 7 mm oil seal from the transmission side using the 42 x 47 mm bearing driver attachment (A) and 15 x 135L driver handle (B).






4. Drive in a new ball bearing (A) from the transmission side using the 65 mm oil seal driver (B).