J35A7
Advanced DiagnosticsDTC P0161: Front Secondary Heated Oxygen Sensor (Secondary H02S (Bank 2, Sensor 2)) Heater Circuit Malfunction (Engine Type: J35A7)
General Description
A heater for the zirconia element is embedded in the front secondary heated oxygen sensor (secondary H02S (bank 2, sensor 2)) and is controlled by the powertrain control module (PCM). When activated, it heats the sensor to stabilize and speed up the detection of oxygen content when the exhaust gas temperature is cold. If the front secondary H02S heater draws other than a specified amperage, the PCM detects a malfunction and stores a DTC.
Monitor Execution, Sequence, Duration, DTC Type, OBD Status
Enable Conditions
Malfunction Threshold
The front secondary H02S heater output is 0.38 A or less, or 3.33 A or more, for at least 5.0 seconds when the heater is on.
Driving Pattern
Start the engine in a cold condition, and let it idle until the radiator fan comes on.
Diagnosis Details
Conditions for illuminating the MIL
When a malfunction is detected during the first drive cycle, a Temporary DTC is stored in the PCM memory. If the malfunction recurs during the next (second) drive cycle, the MIL comes on and the DTC and the freeze frame data are stored.
Conditions for clearing the MIL
The MIL will be cleared if the malfunction does not recur during three consecutive drive cycles in which the engine conditions are similar to the first time the malfunction was detected. The MIL, the DTC, the Temporary DTC, and the freeze frame data can be cleared by using the scan tool Clear command or by disconnecting the battery.