Manufacturer Code Charts: 113

VSA DTC Troubleshooting: 113

DTC 113: Yaw Rate Sensor (Power Supply)

1. Disconnect the yaw rate-lateral acceleration sensor 4P connector.

2. Turn the ignition switch to ON (II).

3. Measure the voltage between body ground and yaw rate-lateral acceleration sensor 4P connector terminal No. 1.

Is there battery voltage?
YES - Go to step 4.

NO - Repair open or high resistance in the wire between the No. 31 (7.5 A) fuse in the under-dash fuse/relay box and the yaw rate-lateral acceleration sensor.






4. Turn the ignition switch to LOCK (0).

5. Reconnect the yaw rate-lateral acceleration sensor 4P connector.

6. Turn the ignition switch to ON (II).

7. Clear the DTCs with the HDS.

8. Turn the ignition switch to LOCK (0), then turn it to ON (II).

9. Check for DTCs with the HDS.

Does the VSA indicator come on, and is DTC 113 indicated?
YES - Check for loose terminal in the yaw rate-lateral acceleration 4P connector. If the connection is good, replace the VSA modulator-control unit. Service and Repair

NO - Intermittent failure, the system is OK at this time. Check for loose or poor connections.