Door Lock Knob Switch Test

Door Lock Knob Switch Test

Driver's Door

1. Remove the driver's door panel. Service and Repair

2. Disconnect the 3P connector from the actuator.

3. Check for continuity between the terminals.
- There should be continuity between terminals No. 2 and No. 3 when the door lock knob switch is in the LOCK position and no continuity when the switch is in the UNLOCK position.

- There should be continuity between terminals No. 1 and No. 3 when the door lock knob switch is in the UNLOCK position and no continuity when the switch is in the LOCK position.

4. If the continuity is not as specified, replace the door lock actuator.






Front Passenger's Door (RTS, RTL, and EXL models)

1. Remove the front passenger's door panel. Service and Repair

2. Disconnect the 3P connector from the actuator.

3. Check for continuity between the terminals.
There should be continuity between terminals No. 1 and No. 3 when the door lock knob switch in the UNLOCK position and no continuity when the switch is in the LOCK position.

4. If the continuity is not as specified, replace the door lock actuator.






Rear Door (RTS, RTL, and EXL models)

1. Remove the left or right rear door panel. Service and Repair

2. Disconnect the 3P connector from the actuator.

3. Check for continuity between the terminals.
There should be continuity between terminals No. 1 and No. 3 when the door lock knob switch is UNLOCK position and no continuity when the switch is in the LOCK position.

4. If the continuity is not as specified, replace the door lock actuator.