Navigation Unit Will Not Eject Or Accept the Navigation DVD (With Navigation)

Symptom Troubleshooting: Navigation unit will not eject or accept the navigation DVD

Navigation unit will not eject or accept the navigation DVD

NOTE:

- Check the vehicle battery condition first. Testing and Inspection

- Check the connectors for poor connections or loose terminals.

1. Check the No. 7 (7.5 A) and the No. 32 (7.5 A) fuses in the under-dash fuse/relay box.

Are the fuses OK?
YES - Go to step 2.

NO - Replace the blown fuse(s), and recheck.


2. Turn the ignition switch to ON (II).

3. Eject the DVD from the navigation unit. Service and Repair

Does the navigation DVD eject?
YES - Go to step 4.

NO - Go to step 5.


4. Reinsert the navigation DVD into the navigation unit.

Does the navigation unit accept the navigation DVD?
YES - No problems at this time, the system is normal. Inspect for loose or poor connections at terminals No. 1, No. 2 and No. 4 of navigation unit connector A (8P).

NO - Replace the navigation unit. Service and Repair


5. Measure the voltage between navigation unit connector A (8P) terminal No. 4 and body ground.

Is there less than 0.2 V or less?
YES - Go to step 6.

NO - Repair open or high resistance in the BLK wire between navigation unit connector A (8P) and body ground (G501).





6. Measure the voltage between navigation unit connector A (8P) terminals No. 1 and No. 2 and body ground.

Is there battery voltage?
YES - Replace the navigation unit. Service and Repair

NO - Repair open in the wire(s) between navigation unit connector A (8P) terminal No. 1 and the No. 7 (7.5 A) fuse in the under-dash fuse/relay box or the navigation unit connector A (8P) terminal No. 2 and the No. 32 (7.5 A) fuse in the under-dash fuse/relay box.