Power Mirror Replacement

Power Mirror Replacement

1. Lower the door glass fully.

2. Carefully release the clip, lift the cover upward to release the hooks (A), and remove the cover (B) in the sequence shown.

3. Remove the front door panel. Service and Repair






4. Disconnect the connector (A).

5. While holding the mirror, remove the nuts securing the mirror.






6. While holding the mirror, squeeze the sides of the connector clip (A), then push out to remove the mirror (B). Take care not to scratch the door.

7. Install the mirror in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly.

- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.