Dashboard Center Lower Cover Removal/Installation

Dashboard Center Lower Cover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Technician Safety Information before doing repairs or service.

NOTE:

- Take care not to scratch the dashboard and related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. From under the dash, detach the clips, release the guide (A), then remove the driver's console side trim (B) and the passenger's console side trim (C).
With navigation system: On the driver's side, disconnect the HandsFreeLink control unit connector (D).






2. Open the center lower pocket (A), and remove it by pulling the bottom of it up.






3. Remove the dashboard center lower cover (A).
-1 Remove the screws (B).
-2 Pull out the cover to release the clips (C, D).
-3 Disconnect the seat heater connectors (E) (for some models) and the accessory socket connectors (F).

4. Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Make sure the each connector is plugged in properly.

- Push the clips into place securely.