SRS Unit Replacement

SRS Unit Replacement

Removal

NOTE: If you are disconnecting only SRS unit connector A, skip step 2.

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Disconnect both seat belt tensioner connectors. Technician Safety Information

3. Remove the driver's and passenger's console side trim. Center Console Removal/Installation

4. Remove the TORX bolts using T30 TORX bit.

5. Disconnect SRS unit connector A (28P) and SRS unit connector B (28P), then pull out the SRS unit.






Installation

1. Install the SRS unit (A) with TORX bolts (B), then connect the connectors (C) to the SRS unit; push them into position until they click.

NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the TORX bolts.

2. Do the battery terminal reconnection procedure. Procedures

3. Install all removed parts.

4. Calibrate the ODS unit. Programming and Relearning

5. Do the ODS unit operation check. ODS Unit Operation Check

6. After installing the SRS unit, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.