ODS Unit Replacement

ODS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Disconnect the passenger's side airbag harness 2P connector. Technician Safety Information

3. Remove the passenger's seat assembly Front Seat Removal/Installation and seat-back cover. Front Seat-Back Cover Replacement

4. Remove the cover (A), then disconnect the ODS unit 18P connector (B) and sensor connectors (C) from the ODS unit (D).

5. Remove the two screws (E) and the ODS unit.






Installation

1. Place the ODS unit (A) on the seat-back frame. Tighten the two screws (B), and connect the ODS unit 18P connector (C) and sensor connectors (D) to the ODS unit. Reinstall the cover (E).

2. Install the seat-back cover in the reverse order of removal.

3. Install the seat assembly, Front Seat Removal/Installation then connect the side airbag harness 2P connector.

4. Do the battery terminal reconnection procedure. Procedures

5. Clear the any DTCs. Initial Inspection and Diagnostic Overview

6. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

7. Initialize the ODS unit. Programming and Relearning

8. After installing the ODS unit, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.