Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal reconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front bumper. Front Bumper

3. Remove the front inner fender. Front Inner Fender Replacement

4. Disconnect the left engine compartment wire harness or right engine compartment wire harness 2P connector (A), and using a TORX T30 bit, remove the two TORX bolts (B), then remove the front impact sensor (C).






Installation

1. Install the front impact sensor with TORX bolts (A), then connect the left engine compartment wire harness or right engine compartment wire harness 2P connector (B) to the front impact sensor (C).

2. Do the battery terminal reconnection procedure. Procedures

3. Clear the any DTCs. Initial Inspection and Diagnostic Overview

4. Install all removed parts.

5. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.