ATF Cooler Line and Hose Assembly Replacement

ATF Cooler Line and Hose Assembly Replacement

1. Disconnect the ATF cooler hose (A) from the ATF cooler line (B).

2. Disconnect the ATF cooler hose (C) from the ATF cooler line (D).

3. Loosen the bolt (E) securing the cooler line bracket, and remove the bolt (F) securing the cooler line bracket.

4. Remove the cooler hose clamp (G) from the clamp bracket.

5. Install a new ATF cooler line and hose assembly (H).

6. Slide the hose end (I) over the cooler line on the ATF cooler under the radiator until the hose end contacts the bend in the line.

7. Secure the hose with the clip (J) at 2-4 mm (0.1-0.2 in.) (K) from the hose end.

8. Slide the ATF cooler hose over the ATF cooler line until the hose end contacts with the bulge (L).

9. Secure the hose with the clip (M) at 6-8 mm (0.2-0.3 in.) (N) from the hose end.

10. Install the cooler hose clamp at the mark (O), then install the clamp on the clamp bracket.