A/T Differential Carrier Bearing Outer Race Replacement

A/T Differential Carrier Bearing Outer Race Replacement

Special Tools Required

- Driver handle 15 x 135L 07749-0010000
- Attachment, 83 mm 07HAD-SG00100
- Attachment, 78 x 80 mm 07NAD-PX40100 or 07GAD-SD40101

NOTE:

- Replace the bearing with a new one whenever the outer race is replaced.

- Do not reuse shim(s) on the torque converter housing side.

- Adjust the preload after replacing the bearing and the outer race.

- Coat all parts with ATF during installation.

1. Remove the bearing outer race (A), the spacer (B), and the 85 mm thrust shim (C) from the transmission housing (D) by heating the housing to about 212 °F (100 °C) with a heat gun (E). Do not heat the housing more than 212 °F (100 °C).






2. Install the 85 mm thrust shim (A), the spacer (B), and the outer race (C) in the transmission housing (D).






3. With the driver handle and attachment (83 mm), drive the outer race securely in the housing so there is no clearance between the outer race, the spacer, the shim, and the housing.






4. Remove the plate (A), and remove the bearing outer race (B) and the spacer (C) from the torque converter housing (D).

5. Install a spacer and a new outer race in the torque converter housing.






6. Drive the bearing outer race securely in the housing with the driver handle and the attachment (78 x 80 mm).

7. Install the plate over the outer race in the torque converter housing.