A/T Transfer Breather Hose Replacement

A/T Transfer Breather Hose Replacement

1. Remove the transfer breather (A) from the throttle cable bracket (B), and disconnect the breather hose (C) from the breather.

2. Remove the transfer breather hose clamp (D) from the heater hose (E), and remove the clamp from the breather hose.






3. Remove the breather hose (upper) (A) from the hose clamp (B).

4. Separate the breather hoses upper and lower (C), and remove the hose joint (D).
If the only upper hose is replaced, remove the upper hose from the hose joint, and go to step 9.

5. Raise the vehicle on a lift, and make sure it is supported securely. Service and Repair






6. Remove the breather hose (A) from the hose clamp (B), and disconnect the hose from the transfer breather pipe (C) on the transfer assembly.

7. Install the breather hose over the transfer breather pipe with the dot (D) on the hose facing out, and install the hose in the clamp at the dot (E) on the hose with facing out.

8. Install the hose joint in the lower hose.

9. Install the upper hose over the hose joint by aligning the upper hose dot with the lower hose dot.

10. Install the upper hose in the clamp at the dot on the upper hose with facing out.

11. Install the transfer breather hose clamp at the covering hose, and install the clamp on the heater hose, centering the heater hose dot in the clamp opening.

12. Install the upper hose end over the breather pipe with the dot on the hose facing up, and install the breather on the throttle cable bracket.