Transmission Position Sensor/Switch: Testing and Inspection

Transmission Range Switch Test

1. Do the battery removal procedure, Removal and Replacement then remove the battery tray.

2. Remove the intake manifold cover, the intake air duct, the resonator, and the air cleaner housing.

3. Remove the battery base.

4. Disconnect the transmission range switch connector.






5. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.

6. The transmission range switch test is finished if the test results are OK.
If there is no continuity between any terminals, check the transmission range switch installation. If the switch installation is OK, replace the switch. Service and Repair

Transmission Range Switch Connector





7. Install the battery base bracket and the battery base.

8. Install the air cleaner housing, the resonator, the intake air duct, and the intake manifold cover.

9. Install the battery tray, then do the battery installation procedure. Removal and Replacement