Wiper/Washer Combination Switch Control Unit Input Test

Wiper/Washer Combination Switch Control Unit Input Test

1. Before troubleshooting the wiper/washer system, troubleshoot B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

2. Remove the steering column covers. Steering Column Removal and Installation

3. Remove the self-tapping screws, then disconnect the 12P connector (A) from the combination switch (B).

4. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.

- If the terminals look OK, go to step 5.

5. With the connector still disconnected, do these input tests at the following connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, go to step 6.





6. Reconnect the 12P connector to the combination switch, turn the ignition switch to ON (II) and do these input tests at the following connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, replace the combination switch control unit.