Operation CHARM: Car repair manuals for everyone.

CVT Drive Pulley Pressure Control Solenoid Valve Test




CVT Drive Pulley Pressure Control Solenoid Valve Test

1. Remove the air cleaner assembly Service and Repair and the intake air duct.

2. Disconnect the solenoid harness connector.





3. Measure the CVT drive pulley pressure control solenoid valve resistance between solenoid harness connector terminals No. 3 and No. 7.





4. If the resistance is out of the standard, check for an open or a short in the solenoid harness. If the wires are OK, replace the CVT drive pulley pressure control solenoid valve CVT Drive Pulley Pressure Control Solenoid Valve Replacement.

5. Connect a jumper wire from the battery positive terminal to solenoid harness connector terminal No. 3, and connect another jumper wire from the battery negative terminal to terminal No. 7. A clicking sound should be heard.

6. If no sound is heard, remove the CVT drive pulley pressure control solenoid valve, and clean it, then recheck. Replace the CVT drive pulley pressure control solenoid valve if a problem recurs CVT Drive Pulley Pressure Control Solenoid Valve Replacement.