Oil Pressure Sender: Service and Repair

Engine Oil Pressure Switch Replacement

1. Remove the front undercover and the splash shield Engine Removal.

2. Remove the A/C condenser fan shroud assembly Service and Repair.

3. Remove the A/C compressor without disconnecting the A/C hoses Engine Removal.

NOTE: Hang the A/C compressor with a rope.

4. Disconnect the oil pressure switch connector (A), then remove the oil pressure switch (B).





5. Remove all of the old liquid gasket from the switch and the switch mounting hole.

6. Apply a very small amount of liquid gasket to the oil pressure switch threads, then install the oil pressure switch.

NOTE: Using too much liquid gasket may cause liquid gasket to enter the oil passage or the end of the new oil pressure switch.

7. Loosely install the A/C compressor mounting bolts and the A/C compressor through bolt in the numbered sequence shown. Failure to follow this sequence may reduce the life of the drive Engine Installation.

8. Install the A/C condenser fan shroud assembly Service and Repair.

9. Install the splash shield and the front undercover Engine Installation.