Under-Dash Fuse/Relay Box Removal and Installation

Under-dash Fuse/Relay Box Removal and Installation

Special Tools Required

- Relay Puller 07AAC-000A1A0

NOTE: SRS components are located in this area. Review the SRS component locations Locations, precautions, and procedures Service and Repair before doing repair or servicing.

Removal

1. Do the battery terminal disconnection procedure Procedures.

2. Remove the left (or right) front door sill trim Front Door Weatherstrip Replacement and left (or right) kick panel Service and Repair.

3. Disconnect the connectors from the fuse side of the driver's (or passenger's) under-dash fuse/relay box (A).










4. Remove the mounting bolt(s) and pull the fuse/relay box away from the body.

5. Disconnect the connectors and remove the driver's (or passenger's) under-dash fuse/relay box.

NOTE: Some SRS harness connectors are spring-loaded lock type Service and Repair.

6. Carefully remove the relays using the relay puller Power Relay Test or by prying under the base of the relay.

NOTE: Do not use pliers; pliers will damage the relay, which could cause the engine to stall or not start.

Installation

1. Install the relays and connect the connectors to the driver's (or passenger's) under-dash fuse/relay box, then install the driver's (or passenger's) under-dash fuse/relay box in the reverse order of removal.

2. Install the removed parts in the reverse order of removal.

3. Do the battery terminal reconnection procedure Procedures.

4. Confirm that all systems work properly.