Torque Converter Housing Intermediary Shaft Bearing Replacement

Torque Converter Housing Intermediary Shaft Bearing Replacement

Special Tools Required

- Adjustable Bearing Puller, 25-40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 52 x 55 mm 07746-0010400

1. Remove the intermediary shaft bearing from the torque converter housing using the 25-40 mm adjustable bearing puller and a commercially available 3/8 ''-16 slide hammer (A).






2. Install the ATF guide plate (A), then install the bearing (B) in the torque converter housing.






3. Drive the bearing until it bottoms out in the torque converter housing using the driver handle and the 52 x 55 mm bearing driver attachment.