Accessory Control Display: Service and Repair

Center Display Unit Removal and Installation

Removal

1. Inner Vent - Both Sides





1. Carefully pry out the inner vents (A) with the appropriate trim tool to detach the clips (B), then remove the inner vents.

2. Audio Unit Assembly





NOTE:
* Eject the discs before removing the audio unit to prevent damaging the CD player's load mechanism.
* If you are replacing the audio unit, write down the audio presets (if possible), then enter them into the new audio unit.
* Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
* Do not work in a dusty or dirty place.
* Discharge static electricity from your body before and during the work.
* Do not touch the circuit board(s) with your bare hands.
* Do not work with dirty hands.
* Do not touch the terminal connector of the flat plate cable with your bare hands (If you have touched it, wipe it off thoroughly.).

1. Remove the bolts.

2. Disconnect the connectors, then pull out the audio unit (A).

3. Dashboard Center Display Visor Assembly





1. Remove the dashboard center display visor (A).

4. Center Display Unit Assembly





1. Remove the center display unit assembly (A).

2. Disconnect the connectors.

5. Front Passenger's Airbag Cutoff Indicator





1. Remove the front passenger's airbag cutoff indicator (A).

6. Center Display Unit





1. Remove the center display unit (A).

Installation

1. Center Display Unit





1. Install the center display unit (A).

2. Front Passenger's Airbag Cutoff Indicator





1. Install the front passenger's airbag cutoff indicator (A).

3. Center Display Unit Assembly





1. Connect the connectors.

2. Install the center display unit assembly (A).

4. Dashboard Center Display Visor Assembly





1. Install the dashboard center display visor (A).

5. Audio Unit Assembly





1. Connect the connectors, then install the audio unit (A).

NOTE: Make sure all the connectors and the antenna lead are secure.

2. Install the bolts (B).

NOTE: If the audio unit was replaced, enter the audio presets that you saved onto the new unit.

6. Inner Vent - Both Sides





1. Install the inner vents (A). Make sure the clips (B) snap into place securely.