Removal
Carpet Removal and Installation
Removal
1. Front Console Cover - Both Sides
Left side
Right side
1. Remove the clips (A).
2. Detach the clips (B), then remove the front console covers (C).
2. Center Console Rear Trim
1. Carefully pry out the center console rear trim (A) with the appropriate trim tool to detach the clips (B) and the hooks (C), then remove the center console rear trim.
3. Center Console
1. Carefully pry out the center lower cover (A) with the appropriate trim tool to detach the clips (B), then remove the center lower cover.
2. Remove the bolt (C).
3. Remove the bolts (A).
4. Remove the console box mat (A), then remove the bolts (B).
5. Disconnect the connectors (A), and remove the clips (B).
6. Slide both front seats fully rearward, and recline the seat-backs around two thirds to the rear.
7. Remove the center console (A).
4. Front Seat Belt Lower Anchor Bolt - Both Sides
NOTE; Repeat on the opposite side.
1. Slide the front seat forward fully, carefully pry up on the bottom edge of the anchor cover (A) at the pry point (B) with the appropriate trim tool to release the hooks (C) and the tab (D), then remove the cover by pulling it up.
2. Remove the lower anchor bolt.
5. Battery Terminal (SRS) - Disconnection
1. Make sure the ignition switch is in LOCK (0).
2. Disconnect and isolate the negative cable (A) from the battery.
NOTE: Always disconnect the negative side first.
3. Disconnect the positive cable (B) from the battery.
4. Wait at least 3 minutes before starting work.
6. Front Seat - Both Sides
NOTE: Repeat on the opposite side.
1. Detach the hooks (A), then remove both seat track end covers (B).
2. The driver's seat is shown; repeat on the passenger's seat.
Front
Rear
3. Remove the seat mounting bolts (A).
4. Push the head restraint release button (A), then remove the head restraint (B).
5. The driver's seat is shown; repeat on the passenger's seat.
Driver's seat
Passenger's seat (Without woofer)
Passenger's seat (With woofer)
6. Lift up the front seat, then disconnect the connectors (A) and detach the harness clip (B).
7. With the help of an assistant, carefully remove both front seats through the front door opening.
7. Front Door Sill Trim - Both Sides
1. Detach the hooks (A) and the tabs (B) from the kick panel (C) and the B-pillar lower trim (D), and pull up the front door inner sill trim (E) by hand to detach the clips (F), then remove the trim.
2. Repeat this step on the opposite side.
8. Rear Door Sill Trim - Both Sides
NOTE: Repeat on the opposite side.
1. Pull the release strap to fold down the rear seat, then lift-up and latch the rear seat-back in the upright position.
2. Detach the hooks (A) and the tab (B) from the B-pillar lower trim (C) and the rear side trim panel (D), and pull up the rear door inner sill trim (E) by hand to detach the clips (F, G), then remove the trim.
9. Front Door Opening Seal As Needed - Both Sides
1. Pull out the front door opening seal (A) from the trim hooks (B) around the front door opening flange, then detach the seal as needed.
2. Repeat this step on the opposite side.
10. Rear Door Opening Seal As Needed - Both Sides
1. Pull out the rear door opening seal (A) from the trim hooks (B) around the rear door opening flange, then detach the seal as needed.
2. Repeat this step on the opposite side.
11. Kick Panel - Both Sides
Driver's side
Passenger's side
1. Pull out the front door opening seal (A) as needed from the kick panel hooks and the door opening flange.
2. Pull back the kick panel by hand to detach the clips (B), then remove the driver's side kick panel (C) and the passenger's side kick panel (D).
12. B-Pillar Lower Trim - Both Sides (After Removing Seats)
NOTE: Repeat on the opposite side.
1. Pull back the bottom portion of the B-pillar lower trim (A) by hand to detach the clips (B).
2. Pull back the upper portion of the B-pillar lower trim to detach the hooks (C), then remove the B-pillar lower trim.
13. Rear Damper Maintenance Cover - Both Sides
NOTE: Repeat on the opposite side.
1. Fold down the rear seat-back.
2. Pull up the rear damper maintenance cover (A) by hand to detach the hooks (B), then remove the rear damper maintenance cover.
14. Rear Seat Cushion Foot Cover - Both Sides
Left side
Right side
1. Pull up the rear seat cushion foot covers (A) by hand to detach the clips (B).
2. Detach the hooks (C), then remove the rear seat cushion foot covers.
15. Left Rear Seat Cushion Assembly
1. Detach the cables (A) from the cable brackets (B), and detach the cable clip (C), then disconnect the cables from the seat cushion assembly (D).
2. Remove the bolts (A) securing the left rear seat cushion assembly (B), then remove the left rear seat cushion assembly.
16. Right Rear Seat Cushion Assembly
1. Detach the cables (A) from the cable brackets (B), and detach the cable clip (C), then disconnect the cables from the seat cushion assembly (D).
2. Remove the bolts (A) securing the right rear seat cushion assembly (B), then remove the right rear seat cushion assembly.
17. Rear Seat-Back Assembly - Both Sides
Left side
Right side
NOTE: Repeat on the opposite side.
1. Detach the clips (A) from the rear carpet trim (B).
2. Remove the bolts (C, D) securing the rear seat-back assembly (E), then remove the rear seat-back assembly.
18. Rear Carpet Trim - Both Sides
Left side
Right side
1. Detach the hooks (A) from the rear side trim panel (B), and pull up the rear carpet trims (C) by hand to detach the clips (D), then remove the rear carpet trims.
19. Steering Joint Cover
1. Remove the steering joint cover (A).
20. Floor Carpet
1. Detach the clips (A).
2. Pull out the floor wire harnesses (B) through the hole in the carpet (C), then remove the carpet.
3. If necessary, remove the floor mat holder (A).
21. Foot Stopper
1. If necessary, remove the clips (A), then remove the foot stopper (B).
22. Rear Wheelhouse Gusset
1. If necessary, remove the bolts and the nuts, then remove the rear wheelhouse gusset (A).