Power Mirror Actuator Test

Power Mirror Actuator Test

Removal

1. Door Mirror Cover





1. Carefully pry out the door mirror cover (A) with the appropriate trim tool to detach the clips (B), then remove the door mirror cover.

2. With tweeter: Disconnect the connector (C).

2. Front Door Power Window Switch Panel





1. Carefully pry out on the notch (A) in the power window switch panel (B) with the appropriate trim tool to detach the clips (C) and the hooks (D). Disconnect the connectors (E), then remove the power window switch panel.

3. Front Door Panel





1. Carefully pry out on the upper hook (A) in the inner handle cap (B) with the appropriate trim tool, then pull back the inner handle cap to remove it.





2. Remove the screws (A) securing the inner handle (B).





3. Remove the pull pocket mat (A), then remove the screw (B).





4. Starting at the bottom edge of the door panel (A), detach the clips (B) with a commercially available trim pad remover.

5. Starting at the rear, pull the door panel upward.

6. Remove the inner handle (C) from the door panel, then remove the door panel.

Test

1. Power Mirror Actuator - Test









1. Disconnect the connector.

2. Check actuator operation by connecting power and ground according to the table.

3. If the mirror fails to work properly, the power mirror actuator is faulty; replace the power mirror.

Defogger Test

4. Check for continuity between power mirror connector terminals No. 4 and No. 12. There should be continuity. If the resistance is not as specified, check for an open or high resistance in the wire between the connector and mirror holder. If the wire is OK, replace the mirror holder.

Installation

1. Front Door Panel





1. Install the inner handle (A) in the door panel (B).

2. Install the door panel. Make sure the clips (C) snap into place securely.





3. Install the screw (A), then install the pull pocket mat (B).





4. Install the screws (A) securing the inner handle (B).





5. Install the inner handle cap (A). Make sure the upper hook (B) and the lower hooks (C) snap into place securely.

2. Front Door Power Window Switch Panel





1. Connect the connectors (A), then install the power window switch panel (B). Make sure the clips (C) and the hooks (D) snap into place securely.

3. Door Mirror Cover





1. With tweeter: Connect the connector (A).

2. Install the door mirror cover (B). Make sure the clips (C) snap into place securely.