Rear Door Weatherstrip: Service and Repair

Rear Door Weatherstrip Removal and Installation

Removal

1. Rear Door Weatherstrip





1. Remove the door checker mounting bolt (A) at the B-pillar.

2. Detach the clips (B, C, D), and release the rear door weatherstrip (E) from the holder (F) of the door sash, then remove the rear door weatherstrip.

Installation

1. Rear Door Weatherstrip





NOTE: Apply medium strength liquid thread lock to the door checker mounting bolt (A) before installation.

1. Install the rear door weatherstrip (B). Make sure the clips (C, D, E) snap into place securely.

2. Install the door checker mounting bolt.

NOTE: Make sure the door weatherstrip is installed in the holder (F) securely.

2. Water Leak Test




Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:
* Use a 12 mm (0.47 in) diameter hose (A).
* Adjust the rate of water flow as shown.
* Do not use a nozzle.
* Hold the hose about 300 mm (12 in) away from the door.