Side Engine Mount Removal/Installation

Side Engine Mount Removal and Installation

Removal

1. Air Cleaner Assembly





1. Disconnect the MAF sensor/IAT sensor connector (A).

2. Remove the harness clamp (B).

3. Disconnect the intake air duct (C) and the intake air pipe (D).

4. Remove the air cleaner (E).

2. Vehicle Lift

1. Raise the vehicle on a lift, and make sure it is securely supported.

3. Front Splash Shield





1. Remove the bolts (A), then remove the clips (B) that secure the front inner fender and the front splash shield (C) to the body.

2. From under the front bumper (D), remove the clips (E).

3. From under the body, remove the clips (F), then pull out the front splash shield.

4. Engine Jack Support (State of a Low Vehicle)

1. Lift and support the engine with a jack and a wood block under the oil pan.

5. Upper Torque Rod





1. Remove the upper torque rod.

6. Side Engine Mount





1. Remove the ground cable (A), the side engine mount bolt (B) and nut (C).





2. Remove the side engine mount.

Installation

1. Side Engine Mount





1. Install the side engine mount.





2. Loosely install the new side engine mount bracket using a new bolt and a new bolt.

3. Install the ground cable.

2. Engine Jack Support (State Of A Low Vehicle)

1. Remove the jack and the wood block.

3. Transmission Mount - Loosen





1. Loosen the transmission mount bracket bolt and nuts (A).

4. Lower Torque Rod Mounting Bolt - Loosen





1. Loosen the lower torque rod mounting bolt (A).

5. Front Engine Mount Mounting Bolt - Loosen





1. Loosen the front engine mount bolt (A).

6. Side Engine Mount - Tighten





1. Tighten the side engine mount bracket mounting bolt and nut.

7. Transmission Mount - Tighten





1. Tighten the transmission mount bracket mounting bolt and nuts.

8. Lower Torque Rod Bolt - Tighten





1. Tighten the lower torque rod mounting bolt (A).

9. Upper Torque Rod





1. Install the upper torque rod using new bolts.

2. Tighten the upper torque rod mounting bolts in the numbered sequence shown.

10. Front Engine Mount Mounting Bolt - Tighten





1. Tighten the front engine mount mounting bolt.

11. Front Splash Shield





1. Install the front splash shield (A), then install the bolts (B) and the clips (C, D). Make sure the clips snap into place securely.

12. Air Cleaner Assembly





1. Install the air cleaner (A).

2. Connect the intake air pipe (B) and the intake air duct (C).

3. Install the harness clamp (D).

4. Connect the MAF sensor/IAT sensor connector (E).