Alarm Module: Service and Repair

Immobilizer-Keyless Control Unit Removal and Installation

Removal

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Upper Column Cover





1. Carefully pry out the dashboard meter visor blind cover (A) with the appropriate trim tool to detach the clips (B) and the hook (C), then tuck up the dashboard meter visor blind cover.





2. Remove the upper column cover (A).

2. Lower Column Cover





1. Turn the steering wheel to the left. Remove the screw (A) securing the lower column cover (B) from the front side.

2. Turn the steering wheel to the right. Remove the screw securing the lower column cover from the front side.





3. Remove the screw (A), then remove the lower column cover (B).

3. Immobilizer-Keyless Control Unit





1. Disconnect the connector.

2. Remove the immobilizer-keyless control unit (A).

Installation

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Immobilizer-Keyless Control Unit





1. Install the immobilizer-keyless control unit (A).

2. Connect the connector.

2. Lower Column Cover





1. Push in on the lower column cover just above ignition switch opening (A) to engage the column cover with the locking tab (B).





2. Install the lower column cover (A), then install the screw (B).





3. Turn the steering wheel to the left. Install the screw (A) securing the lower column cover (B) from the front side.

4. Turn the steering wheel to the right. Install the screw securing the lower column cover from the front side.

3. Upper Column Cover





1. Install the upper column cover (A).





2. Install the dashboard meter visor blind cover (A). Make sure the clips (B) and the hook (C) snap into place securely

4. HDS DLC - Connection





1. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

2. Turn the ignition switch to ON (II).

3. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

5. Immobilizer keyless Control Unit - Registration

1. Do the immobilizer keyless control unit registration. Testing and Inspection

6. Immobilizer Key - Registration

1. Do the immobilizer key registration. Testing and Inspection