Drivers Power Seat Adjustment Switch Removal, Installation, And Test

Driver's Power Seat Adjustment Switch Removal, Installation, and Test

Removal

SRS components are located in this area. Review the SRS component locations Pinout Values and Diagnostic Parameters and the precautions and procedures Locations before doing repairs or service.

NOTE: Before the front power seat is removed, slide the front power seat to the half-way position, then raise the seat to the highest position.

1. Front Cover





1. Remove the screw (A), and release the hook (B), the pin (C), and the tabs (D), then remove the front cover (E).

2. Front Seat Recline Cover





1. Remove the screw (A), and detach the clip (B).

2. Release the tabs (C).

3. Pull up the recline cover (D) to release the hook (E).

4. Disconnect the connectors.

5. Remove the upper center inner cover (F).

6. Remove the wire harness (G) from the hooks (H), then remove the recline cover.

3. Power Seat Adjustment Switch





1. Remove the power seat adjustment switch knobs (A).

2. Remove the power seat adjustment switch (B) from the recline cover (C).

Test

1. Power Seat Adjustment Switch - Test





1. Reinstall the power seat adjustment switch knobs (A) to the power seat adjustment switch (B).

2. Check for continuity between the terminals in each position according to the table.






3. If the continuity is not as specified, replace the power seat adjustment switch.

Installation

SRS components are located in this area. Review the SRS component locations Pinout Values and Diagnostic Parameters and the precautions and procedures Locations before doing repairs or service.

1. Power Seat Adjustment Switch





1. Install the power seat adjustment switch (A) from the recline cover (B).

2. Install the power seat adjustment switch knobs (C).

2. Front Seat Recline Cover





1. Install the upper center inner cover (A) to the recline cover (B).

2. Connect the connector, then install the wire harness (C) to the hooks (D).

3. Install the clip (E) and tabs (F), then install the recline cover.

4. Install the tabs (G), then install the screw (H).

3. Front Cover





1. Install the tabs (A), set the pin (B), and install the hook (C), then install the front cover (D). Make sure the hooks snap into place securely.