Removal and Replacement

Alternator Removal and Installation





*Available through the Honda Tool and Equipment Program 888-424-6857

Removal

1. Battery Terminal - Disconnection





1. Make sure the ignition switch is in LOCK (0).

2. Disconnect and isolate the negative cable (A) from the battery.

NOTE: Always disconnect the negative side first.

3. Disconnect the positive cable (B) from the battery.

2. Drive Belt





1. Move the auto-tensioner (A) using the belt tension release tool in the direction of the arrow to relieve tension from the drive belt, then remove the drive belt.

3. Idler Pulley Base Assembly





1. Remove the idler pulley base.

4. Auto-Tensioner Assembly





1. Remove the auto-tensioner.

5. Alternator





1. Remove the three bolts securing the alternator.





2. Disconnect the connector and the cable.

3. Remove the alternator.

Installation

1. Alternator





1. Connect the connector and the cable.

2. Install the alternator.





3. Install the three bolts securing the alternator.

2. Auto-Tensioner Assembly





1. Install the auto-tensioner.

3. Idler Pulley Base Assembly





1. Install the idler pulley base.

4. Drive Belt





1. Install the drive belt.

5. Battery Terminal - Reconnection





NOTE: If the battery performance is abnormal, test the battery.

1. Clean the battery terminals.

2. Connect the positive cable (A) to the battery.

NOTE: Always connect the positive side first.

3. Connect the negative cable (B) to the battery.

4. Apply multipurpose grease to the terminals to prevent corrosion.