A/T Clutch Pressure Control Solenoid Valve A Removal And Installation

A/T Clutch Pressure Control Solenoid Valve A Removal and Installation

Removal

1. Air Cleaner Assembly





1. Disconnect the MAF sensor/IAT sensor connector (A).

2. Remove the harness clamp (B).

3. Disconnect the intake air duct (C) and the intake air pipe (D).

4. Remove the air cleaner (E).

2. Intake Air Duct





1. Remove the intake air duct.

3. A/T Clutch Pressure Control Solenoid Valve A





1. Remove A/T clutch pressure control solenoid valve A.

2. Remove the 35 mm ATF pipe (B), the ATF joint pipes (C), the O-rings (D), and the gasket (E).

3. Check the fluid passage for contamination.

Installation

1. A/T Clutch Pressure Control Solenoid Valve A





1. Clean the mounting surfaces and the fluid passages of the solenoid valve body and the transmission housing.

2. Install a new gasket (B) with its blue side toward the transmission housing, and install the 35 mm ATF pipe (C) and the ATF joint pipes (D).

3. Install new O-rings (E) over the ATF joint pipes.

4. Install A/T clutch pressure control solenoid valve A.

5. Check the connector (F) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

2. Intake Air Duct





1. Install the intake air duct.

3. Air Cleaner Assembly





1. Install the air cleaner (A).

2. Connect the intake air pipe (B) and the intake air duct (C).

3. Install the harness clamp (D).

4. Connect the MAF sensor/IAT sensor connector (E).