Shift Interlock Switch: Testing and Inspection

Park Pin Switch Test

Removal

1. Front Console Cover - Both Sides

Left side

Right side

1. Remove the clips (A).

2. Detach the clips (B), then remove the front console covers (C).

2. Center Console Rear Trim

1. Carefully pry out the center console rear trim (A) with the appropriate trim tool to detach the clips (B) and the hooks (C), then remove the center console rear trim.

3. Center Console

1. Carefully pry out the center lower cover (A) with the appropriate trim tool to detach the clips (B), then remove the center lower cover.

2. Remove the bolt (C).

3. Remove the bolts (A).

4. Remove the console box mat (A), then remove the bolts (B).

5. Disconnect the connectors (A), and remove the clips (B).

6. Slide both front seats fully rearward, and recline the seat-backs around two thirds to the rear.

7. Remove the center console (A).

Test

1. Park Pin Switch - Test

1. Disconnect the connector.

2. Check for continuity between connector terminals No. 6 and No. 9.

* There should be no continuity when the shift lever is moved to P and the shift lever button is released.
* There should be continuity when the shift lever button is pressed or the shift lever is moved out of P.

3. If the continuity is not as specified, the park pin switch is faulty, replace the shift lever/shift cable bracket assembly.

4. Connect the connector.

Installation

1. Center Console

1. Install the center console (A).

2. Connect the connectors (A), and install the clips (B).

3. Install the bolts (A), then install the console box mat (B).

4. Install the bolts (A).

5. Install the bolt (A), then install the center lower cover (B). Make sure the clips (C) snap into place securely.

2. Center Console Rear Trim

1. Install the center console rear trim (A). Make sure the clips (B) and the hooks (C) snap into place securely.

3. Front Console Cover - Both Sides

Left side

Right side

1. Install the front console covers (A). Make sure the clips (B, C) snap into place securely.