Transmission Mode Switch: Service and Repair
D3 Switch Removal and Installation
Removal
1. Shift Lever Panel (AT)
1. Carefully pry out the shift lever panel (A) with the appropriate trim tool to detach the clips (B, C) and the hooks (D), then remove the shift lever panel.
2. Center Maintenance Cover
1. Remove the maintenance cover (A).
3. D3 Switch Harness - Disconnection
1. Remove the harness wire tie (A).
2. Disconnect the D3 switch connector (B).
4. Shift Lever Knob/Shift Lever Knob Ring Assembly
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Unhook the D3 switch harness (A) from the harness guide (B).
2. Remove the shift lever knob/shift lever knob ring assembly (C).
5. Shift Lever Knob Ring
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Remove the shift lever ring (A).
6. Shift Lever Knob Cover - Driver's Side
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Wrap the end of a flat-tip screwdriver (A) with tape, remove the shift lever knob cover (B) using the screwdriver.
2. Remove the shift lever button (C) and the spring (D).
7. D3 Switch
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Remove the D3 switch (A) by expanding the lock tabs (B).
Installation
1. D3 Switch
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Install the D3 switch (A).
2. Shift Lever Knob Cover - Driver's Side
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Install the spring (A) and the shift lever button (B).
2. Install the shift lever knob cover (C).
3. Shift Lever Knob Ring
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Install the shift lever ring (A).
4. Shift Lever Knob/Shift Lever Knob Ring Assembly
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble or assemble it.
1. Install the shift lever knob/shift lever knob ring assembly (A).
2. Hook the D3 switch harness (B) to the harness guide (C).
5. D3 Switch Harness - Reconnection
1. Connect the D3 switch connector (A).
2. Route the D3 switch harness (B) along with the shift lever assembly, and tie the harnesses at the guide (C) with the harness wire tie (D).
6. Center Maintenance Cover
1. Install the maintenance cover (A).
7. Shift Lever Panel (AT)
1. Install the shift lever panel (A). Make sure the clips (B, C) and the hooks (D) snap into place securely.