SRS System

Control System DTCs

SRS DTC Troubleshooting: 62-2x

DTC 62-2x ("x" can be 0 thru 9 or A thru F) : Short in the Front Passenger's Seat Belt Buckle Switch

NOTE:
* Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed Service and Repair.
* Before doing this troubleshooting procedure, review SRS Precautions and Procedures Service and Repair and General Troubleshooting Information Reading and Clearing Diagnostic Trouble Codes.


1. Problem verification:

-1. Clear the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

-2. Turn the ignition switch to ON (II), then wait for 10 seconds. Buckle and unbuckle the front passenger's seat belt several times.

-3. Check for DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Is DTC 62-2x indicated?
-YES- The failure is duplicated. Go to step 2.
-NO- Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures Reading and Clearing Diagnostic Trouble Codes. If another DTC is indicated, troubleshoot the DTC.

2. Front passenger's seat belt buckle switch check:

-1. Turn the ignition switch to LOCK (0).

-2. Disconnect the front passenger's seat belt buckle switch 2P connector (A) on the floor wire harness or the front passenger's seat wire harness.






-3. Clear the DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

-4. Turn the ignition switch to ON (II), then wait for 10 seconds.

-5. Check for DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

Is DTC 62-2x indicated?
-YES- Short to ground in the floor wire harness or the front passenger's seat wire harness; replace the faulty harness, then clear the DTC.
-NO- Faulty front passenger's seat belt buckle switch; replace the front passenger's seat belt buckle assembly Front Seat Belt Buckle Removal And Installation, then clear the DTC.