Manufacturer Code Charts: 83

Control System DTCs

TPMS DTC Troubleshooting: 83

DTC 83 : No VSP Signal






If DTC 85 stored at the same time as DTC 83, troubleshoot DTC 85 first, then recheck for DTC 83.






1. PCM check:

-1. Turn the ignition switch to ON (II).

-2. Clear the DTC with the HDS.

-3. Test-drive the vehicle at 7 mph (10 km/h) or more.

-4. Check the speedometer.

Does the speedometer register speed?
-YES- Go to step 2.
-NO- Update the PCM if it does not have the latest software PCM Update, or substitute a known-good PCM Service and Repair, then go to step 1 and recheck. If the PCM was updated and DTCs are not indicated, troubleshooting is complete. If the PCM was substituted and DTCs are not indicated, replace the original PCM Service and Repair.

2. TPMS control unit check:

-1. Check the parameter(s) below with the HDS.

Is the vehicle speed indicated?
-YES- Intermittent failure, the system is OK at this time.
-NO- Substitute a known-good TPMS control unit Service and Repair, and recheck.