Inspection

Valve Stem-to-Guide Clearance Inspection

























*Available through the Honda Tool and Equipment Program 888-424-6857.


Inspection

1. Valve - Inspection

1. Measure the valve in these areas.


















2. Valve Stem To Guide Clearance - Inspection

1. Subtract the O.D. of the valve stem, measured with a micrometer, from the I.D. of the valve guide, measured with an inside micrometer or a ball gauge. Take the measurements in three places along the valve stem and three places inside the valve guide. The difference between the largest guide measurement and the smallest stem measurement should not exceed the service limit.