Instrument Panel Control Module: Service and Repair

Gauge Control Module Removal and Installation

Removal

1. Gauge Control Module Data - Rewriting

1. ---

2. Dashboard Meter Visor





1. Carefully pry out the dashboard meter visor blind cover (A) with the appropriate trim tool to detach the clips (B) and the hook (C), then tuck up the dashboard meter visor blind cover.





2. Pull out the dashboard meter visor assembly (A) with the appropriate trim tool to detach the clips (B, C) and the tabs (D), then remove the dashboard meter visor assembly.

3. Gauge Control Module




NOTE: Spread a protective cloth on the upper column cover for protect the upper column cover.

1. Adjust the steering column to full tilt down position and to the full telescopic pull position.

2. Remove the gauge control module (A).

3. Disconnect the connector.

Installation

1. Gauge Control Module





NOTE: Spread a protective cloth on the upper column cover for protect the upper column cover.

1. Connect the connector.

2. Install the gauge control module (A).

2. Dashboard Meter Visor





1. Install the dashboard meter visor assembly (A). Make sure the clips (B, C) and the tabs (D) snap into place securely.





2. Install the dashboard meter visor blind cover (A). Make sure the clips (B) and the hook (C) snap into place securely.

3. Rewriting the ODO Data and Transferring the Maintenance Minder(TM) Data to a New Gauge Control Module

1. Do the rewriting the ODO data and transferring the maintenance minder(TM) data to a new gauge control module Testing and Inspection